Durable Concrete Floors in Portland for Every Room
A finished concrete floor lasts decades with minimal upkeep and no allergens. We build them polished, epoxy-coated, stained or with a micro-topping overlay, whether you are starting fresh or resurfacing an existing slab. Every project begins with a free written estimate and a site assessment.
A polished, epoxy, stained or micro-topping finish is only as good as the slab beneath it. Uneven surfaces, low spots and cracks show through every finish, so we address the base first.
When a slab is out of tolerance, self-leveling underlayment brings it into spec before any finish is applied. If radiant heating is part of the plan, heated floor underlayment encases the tubing in the same operation.
We inspect the existing concrete for moisture, damage, flatness and any old coatings, then recommend the finish that fits the room and the slab condition.
Prepare the surface
We grind or shot-blast to remove old finishes and contaminants, repair cracks or spalling, and pour self-leveling underlayment where the slab is uneven.
Install the finish
We apply the chosen finish, polished, epoxy, stain or micro-topping, following the manufacturer system from primer through topcoat.
Cure and handoff
The finish cures per spec, we walk the floor with you, and you receive care instructions to keep the concrete looking new for years.
Match the room
Concrete Floor Finishes Tailored to Your Space
The room's use and light determine the best finish. A polished concrete floor works well in open-concept living areas and basements, delivering brightness and easy cleaning, while an epoxy floor coating suits utility rooms and workshops with its seamless, chemical-resistant surface.
For warmth and visual depth, stained concrete brings acid or water-based colour into kitchens and sunrooms, and a micro-topping overlay creates a fresh, seamless surface over sound but worn concrete without the cost of a tear-out.
Finishes, prep, cost and what concrete floors are like to live with in Portland.
We finish concrete floors polished, epoxy-coated, stained or with a micro-topping overlay, plus the self-leveling and heated-floor underlayment prep that goes underneath them.
Yes. Most residential floor work is done over an existing slab. We assess it for moisture, cracks and flatness, grind or repair as needed, and pour self-leveling underlayment if the surface is out of tolerance before the finish.
They are no colder than tile and pair well with radiant heat encased in heated-floor underlayment. They are hard, which is also why they are durable, low-maintenance and allergen-free, with no grout lines or carpet to hold dust.
Concrete floor finishes generally run $6 to $15 per square foot depending on the finish, the slab condition and how much prep or underlayment is needed. We confirm it with a written, itemised quote after seeing the slab.
We grind or shot-blast the surface and pour self-leveling underlayment where the slab is uneven. A finish only looks as good as the slab under it, so flat comes before anything decorative.
Homeowner reviews
What Portland Homeowners Say About Their Concrete Floors
Polished the whole main floor after a reno. It is bright, dead easy to clean, and the self-leveler they poured first means there is not a single high spot.
V. S.
Portland
★★★★★
Epoxy floor in the basement utility room. Seamless, wipes clean, and they built it up in proper coats instead of one quick layer.
D. A.
Gresham
★★★★★
Stained the kitchen floor a warm brown. The colour has depth you do not get from tile, and there are no grout lines to scrub.
M. R.
Hillsboro
★★★★★
Micro-topping over an old cracked slab in the sunroom. New seamless surface for a fraction of a tear-out, and you cannot tell what was underneath.
E. T.
Beaverton
From the blog
Concrete Guides & Articles
Practical reading on planning, finishes and caring for concrete in Portland.
